Zontes ZT350T-D, Maintenance Manual, Page: 101 / 152

101 / 152
d. Remove the oil pump plug in the same way. Pinch the
snorkel clamp and move it down, and pull out the snorkel.
Press the anti-release buckle of the high-pressure oil pipe at
the end of the oil pump, and pull the high-pressure oil pipe
along the axis of the oil outlet of the oil pump.
e. Use needle-nose pliers to slightly clamp the cable tie
and push it up to remove it from the bracket.
f. Use a 10# sleeve to remove the 4 M6
×
12 bolts (1) that
fix the fuel tank.
g. After confirming that the high-pressure oil pipe, vent
pipe and oil level sensor plug have been unplugged, stand on
the right side of the vehicle to facilitate the removal of the
fuel tank assembly. Hold up the fuel tank assembly and turn
it clockwise (as shown in Figure 1), while turning, let the
seam welding on the right side of the fuel tank go down to
the bottom of the bracket (as shown in Figure 2). Turn
clockwise about 90 degrees and turn the fuel tank assembly
forward (as shown in Figure 3). After adjusting the position
continuously, remove the fuel tank assembly (see Figure 4).
Because it is difficult to describe the process in detail, it takes
many patience to try.
2. Disassemble the fuel pump
Turn the fuel tank assembly over and place the fuel pump
facing upwards firmly. The small wooden stool can be turned
over to ground the surface of the stool and put the fuel tank
assembly on.
Loosen 5 bolts
⑴
diagonally with a 10# sleeve, grasp the
high-pressure oil pipe bracket
⑵
, and remove the bolt
⑴
completely.