3、INDUCTION SYSTEM COMPONENT
17
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1244200-017000 ZT310
－
R Air filter large air inlet
1
2
1224200-171000 ZT310-T1 Air Filter (Bosch)
1
3
1251100-101000 Non-standard bolt M6×12
（
304stainless steel
）
5
4
1251300-063093 Plywood M6×11×15
（
Environmental protection
）
5
5
1051354-004000
Φ56×10 Hoop assembly
1
6
1050954-035000 ZT310-R Fuel injector high pressure oil pipe unit
1
7
1274200-034000 ZT310
－
R Rear disc brake tubing clamp (steel)
1
PROCEDURE:
●
High-pressure oil pipe
First press the high pressure oil pipe(2),the anti-loose snap ring close to the fuel pump connector and pull
it out directly.A small amount of fuel in the oil pipe needs to be caught in the oil can; prevent fuel from
dripping to any part of the vehicle. Fireworks should be strictly forbided during the disassembly process.
●
Air filter
Fisrt use the inner hexagon tool to remove the bolt(3),Pull off the brake oil pipe from the oil pipe
clamp(7) and remove it. Loosen the pipe clamp assembly(5) on the end of the air filter, Clamp the clamp
on the exhaust pipe with pliers and unplug the exhaust pipe connected to the exhaust port of the
engine.Then use the rubber plug that is delivered with the car when buying the car to prevent foreign
matter from entering the damaged engine.Remove the air filter(2) and the plywood nut(4),finally pull out
the air inlet(1).
CAUTION:
●
First it need to remove the cushion,side cover,oil tank outside cover and liner,rear shock absorber and
electrical device box etc.
●
When removing the high pressure oil pipe,It is sure to operate until the engine and muffler are completely
cooled.
●
Fireworks, answering or dialing should be strictly prohibited near the car-breaking site to prevent
accidents.
FIG.2 INTAKE SYSTEM
COMPONENT
Intake system component (Bosch EFI)
