8、FRONT FORK COMPONENT
57
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251100-061093 M6×22 Hex flange face full thread bolt
1
2
1224100-044000 Wheel speed sensor clamp
3
3
1251100-080094 Non-standard bolt M8×37 (color zinc)
2
4
1224100-051000 0 Flame retardant tie (black 2.5×100)
1
5
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
1
1184100-081000 ABS Anti-lock braking system wheel speed sensor
stop selling
1184200-045000 DF30wheel speed sensor
7
1251100-102000 Non-standard bolt M6×16 (304 stainless steel)
6
8
1274100-057095
Bush φ6.2×φ8.4×3.5
＋
φ14×1.5
6
9
1244100-052000 Gum cushion, bush
（
φ8.5×φ14×1
）
6
4044201-383063 bright blue front mud board component
blue
4044201-386001 pearl white front mud board component
white
4044201-384021 special black front mud board component
black
4044201-385051 deep bright gray front mud board component
gray
4044201-387011 ruby red front mud board component
red
4044201-391001 pearl white front mud board component
（
GP
）
white GP
4044201-390021 special black front mud board component
（
GP
）
black GP
4044201-392051 deep bright gray front mud board component
（
GP
）
gray GP
11
1274200-038000 ZT310-X Front mudguard front oil pipe fixing seat
1
12
1250402-001091
GB12615φ3×10
1
PROCEDURE:
●
Wheel speed sensor
Pull out the plug of the wheel speed sensor
⑹
; then remove the clamp
⑵
. Cut the tie (4); remove the bolt
⑶
and remove the sensor
⑹
.
●
Front disc brake caliper
Remove the bolts
⑴
and
⑶
so that the caliper will hang down naturally. It is forbidden to invert the
caliper to prevent the air from entering and causing the brake to fail.
●
Front mudguard
Hold the front mud plate
⑽
with your hand and then remove the 4 bolts
⑺
with the hexagonal tool and
remove the bushing
⑻
and cushion rubber
⑼
.
Remove the front mudguard
⑽
.
The inside of the front mudguard can be protected with reticle or double-sided tape around the rivet
⑿
,
then the rivet
⑿
is ground off with a small sander, and then the rivet
⑿
and the fixing seat
⑾
are removed.
10
1
CAUTION:
●
Disassemble the oil pipe clamp and the sensor wire clamp should pay attention to the strength.
●
Pay attention to the strength when disassembling the front mud plate to prevent scratching the paint surface.
●
The ABS Anti-lock braking system wheel speed sensor has been stop selling ,it can be replaced as DF30 wheel
speed sensor.
●
The mudguard component has been included Front mudguard front oil pipe fixing seat
⑾
and Rivet
⑿
.
6
1
Fig.9 FRONT FORK
COMPONENT
Front mudguard & wheel speed sensor component
1184100-081000
1184200-045000
