8、FRONT FORK COMPONENT
53
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1194100-002000 ZT250-S Right rearview mirror
1
3
1134100-032000 ZT250-R Right Hand Rocker (Machine)
1
4
1134200-023000 ZT250-R balance block
1
5
1244100-042000 ZT250-R Right hand rubber sleeve
1
1184200-086000 ZT310-X right hand switch(TFT)
Stop selling
1184200-145000 Second Generation Right Handlebar Switch (TFT)
New
1184200-023000 ZT310-X right hand switch
Stop selling
1184200-151000
Second Generation Right Handlebar Switch (Liquid crystal)
New
7
1250205-031091 GB70.1M6×30 (stainless steel)
2
New
Old
Fig.5 FRONT FORK
COMPONENT
Right handlebar component
2
1100300-044000 ZT125T Front disc brake main pump component
(without handle)
1
6
1
PROCEDURE:
●
Rearview mirror
Hold the mirror stem in one hand, remove the nut
④
with a sleeve, and remove the small pad
③
, the spring
②
and the large pad
①
. Remove the mirror from the front brake master pump.
●
Right handlebar to put rubber sleeve, balance block
Push the rubber sleeve
⑸
with the right handlebar to push forward to expose the upper balance block fixing
hole; use the tool to press the convex parts at both ends of the elastic block on the balance block and pull out the
balance block assembly
⑷
, and then put the right handle Remove the rubber sleeve
⑸
.
●
Right handlebar half cover
Hold the front disc brake main pump
⑵
with one hand, and remove the bolt
⑺
with the hexagon socket tool.
Remove the wire plug connector of the sub switch
⑹
and pull it out.
CAUTION:
●
The motorcycle should be fixed after horizontal support.
●
Periodically check that the fluid level of the brake fluid is between 3/4 of the observation window.
●
Do not flush the cup directly with high pressure water.
●
When assembling the balance block, align the protruding parts at both ends of the shrapnel with the fixing
holes on the handle and then insert the direction into the holes.
●
The small spacer of the rear view mirror anti-rotation limit slot needs to be aligned with the slot on the mirror
bar bolt.
●
The right handlebar refers to the switch to replace the throttle line.
●
The joint between the front disc brake main pump and the half cover should be aligned with the right hand to
match the triangle on the switch.
●
Old switch can be replaced as new models.
TFT
TFT
