9、FUEL TANK COVER COMPONENT
83
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
REMARKS
1
1224100-010000 ZT250
－
S swell nail
2
2
1251100-102000 Non-standard bolt M6×16
（
304stainless
）
2
3
1274100-007000 ZT250-S flanging sleeve
（
φ6.4×φ9×6
＋
φ20×2
）
2
A
B
C
D
E
F
Fig.1 FUEL TANK
COVER COMPONENT
Tank housing assembly 1
（
Small fuel tank
）
PROCEDURE
：
●
Middle cover components
Some of the X1 models produced in the early stage were in a small fuel tank state (Fig. A). The fuel tank cap
was far from the upper surface of the tank cover and the tank box was visible. Here, explain the disassembly of
the fuel tank cover in the state of the small fuel tank.
Press the center of the expansion nail down with a small cross screwdriver
（
As photoB
、
C show
），
Remove
the expansion nail (1) of the rear and front parts of the hood assembly
。
Drag up the back of the middle cover assembly
（
As photoD show
），
Pull out all the middle cover component
buckle
。
Lift the cover assembly with one hand
，
Remove the bolt with other hand
⑵，
Remove the liner
⑶（
As E
show
）。
Pull the right fuel tank trim out
，
take out the fuel tank lock cable
①
from right fuel tank cover and the gap of
fuel tank inner tank.
Find the lock cable plug of the fuel tank at the back of the right cover and the tank inner tank (figure F) and
unplug it, then remove the middle cover assembly.
CAUTION
：
●
The material parts should be protected during disassembly to prevent damage to the paint surface.
●
When removing the buckle, attention should be paid to the strength and direction to prevent damage to the
buckle. .
●
When assembling, please pay attention to check whether the cable is directly pressed or interfered by other
parts to prevent short circuit caused by abrasion.
(Small fuel tank)
