4、REAR WHELL COMPONENT
23
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251100-105000 ZT310
－
Z Chain adjusting bolt M10×70
2
2
1251300-050000 ZT310
－
Z Chain adjuster nut M10
2
1032142-073035 ZT310 R, chain adjuster(Titanium)
1032142-075051 ZT310 R, chain adjuster(dark gray)
4
1251300-067000 ZT250
－
R rear wheel axle nut
1
110N.m
1032142-072035 ZT310 L, chain adjuster(Titanium)
1032142-074051 ZT310 L, chain adjuster(dark gray)
6
1094100-032000 ZT250
－
R rear wheel axle
1
7
1274200-002000
ZT310 Rear wheel right axle sleeveφ20×φ28×φ38×18.5
1
8
1244200-050000 ZT310
－
T Sprocket gum cushion
5
9
1094200-011000 ZT310
－
R Sprocket bracket
1
10
1080100-068000 ZT310
－
T 520
－
42T sprocket
1
11
1251300-057093 Non standard nut M10×1.5
（
DACROMET
）
5
12
1274100-106000
ZT250
－
R rear wheel left axle sleeveφ20×φ30×φ35×12.9
1
5
Fig.3 REAR WHELL
COMPONENT
3
1
●
Rear wheel assembly
Disassemble rear wheel axle nut
⑷
with socket sleeve.
Use open spanner to move chain adjuster nut
⑵
on both sides towards rear wheel axle until they reach chain
adjusting bolt
⑴
. Then rotate the bolt and nut towards motorcycle front direction till the end.
Push rear wheel assembly towards motorcycle front direction and take off the chain from sprocket.
Hold the rear wheel assembly. Punch rear wheel axle
⑹
with rubber hammer. Take off right chain adjuster
⑶
,
right axle sleeve
⑺
, rear tire and rim assembly, left axle sleeve
⑿
, left chain adjuster
⑸
. Tie firmly the rear disc
brake clamp and avoid it to be lifed higher than disc brake oil cup. Disassemble the rear wheel axle at last.
●
Sprocket bracket assembly
Put down the rear wheel assemble horizontally. Take off nut
⑾
with socket sleeve. Take off sprocket
⑽
;
sprocket bracket
⑼
. Pull out the sprocket gum cushion
⑻
from the rim.
CAUTION:
●
Use suitable tool to support the motorcycle. Avoid accidents caused by falling motorcycle. Single person
manipulation is prohibited.All the standard parts need to reach standard torque while reassembling.
●
Using iron hammer to punch rear wheel axle, disc brake clamp assembly is prohibitd.
●
While disassembling the rear wheel assemble, avoid the rear disc brake clamp to be lifted higher than the disc
brake oil cup. If not, air will get into the tubes and cause softness or failure on braking system. As disc brake
tubes request extreamly high vaccum degree. Make sure manipulator has maintenance ability before
disassembling the disc brake assembly.
●
Check the chain regularly. Clean the chain every 1500km is suggested. Keep the tightness of chain to be in a
suitable range. Too loose chain have possibility to separate from sprocket or damage the engine. Too tight chain
can be worn out quickly.
Rear wheel component 1
1
