8、FRONT FORK COMPONENT
77
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1224100-025000 ZT250-SM8 bolt decorative buckle
4
2
1250205-023000 GB70.1 M8×35 (environmental color zinc)
10
3
1134200-005000 ZT310-R direction press block (homemade)
1
4
1134200-003000 ZT310-R direction
1
5
1251300-045000 ZT250-S upper plate decorative nut (chrome plated)
1
6
1251500-050000
upper plate gasket φ18.5×φ39×1 (chrome plated)
1
9
1174100-001000 ZT250-S reflector
2
after-sales
1114200-023000 ZT310-X front left shock absorption (improved
version)
1114200-024000 ZT310-X front right shock absorption (improved
version)
PROCEDURE:
●
Directional components
Use a blade to pick up the decorative buckle
⑴
, hold the direction handle
⑷
in one hand, and remove the bolt
⑵
with a hexagonal tool in one hand; remove the clamp
⑶
and finally remove the direction handle
⑷
.
●
Uplink board assembly
Locate the faucet lock plug and remove it; remove the nut
⑸
and remove the shims
⑹
. Remove the upper plate
bolts
⑵
.
●
Front left and right shock absorption
Remove the bolts
⑵
on the lower link, and hold the shock absorber in the middle with one hand. Insert a slotted
screwdriver into the slot of the upper and lower plates to slightly enlarge the slot clearance, and disassemble the
left shock absorber
⑺
and the right shock absorber
⑻
. under. Remove the upper plate assembly.
●
Reflecting film
The reflector
⑼
is for replacement after sale (no shock reduction). The heat-reflecting sheet can be moved back
and forth by a hot air blower to reduce the viscosity of the double-sided adhesive after being heated, and the
residual glue should be cleaned after removing the reflector.
CAUTION
：
●
The vehicle support should be fixed during the disassembly process to prevent accidents caused by dumping.
●
The front disc brake main pump 1 should always be in the high position during the disassembly process. It is
forbidden to invert or dump to prevent air from entering the brake oil circuit.
●
Use a flat-blade screwdriver to enlarge the gap between the upper and lower joint plates without applying
excessive force to avoid damage.
●
The direction of the upper scale 2 coincides with the edge of the clamp, and the centering and alignment scale
should be paid attention to during assembly.
●
For the disassembly of the lower board components, see "Steering Adjustment" above, which will not be
repeated here.
7
1
8
1
contain reflector
Fig.29 FRONT FORK
COMPONENT
Direction handle, upper plate, front shock absorbing
assembly
