Removing the Front Enclosure Module
9650-0804-01 Rev. A
ZOLL Propaq M Service Manual
47
Removing the Front Enclosure Module
Tools Required
•
#2 Phillips screwdriver with torque capability
•
Orange (wooden) stick
Setup
•
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
1.
“Removing the Handle” on page 43
2.
“Disassembling the Main Unit” on page 44
To reinstall the front enclosure module, reverse the steps.
Front Enclosure Disassembly
1
Remove tape from the top of the unit.
2
Separate monitor front enclosure.
3
Pivot top up with cables still connected.
4
Remove grounding screw as shown in the
illustration.
Note: During reassembly, torque screw to 6
in-lbs.
5
Disconnect the front panel multi-wire cable
in the area illustrated.
grounding
screw
multi-wire
cable
Summary of Contents for Propaq M
