Zigler Z-2312, Instruction Manual

Page: 27 / 49

OPERATION AND MAINTENANCE MANUAL
Semi-automatic BOV Crimping Machine Z-2312
A0310.01.2312.905.1.EN Page 27/33
6.5. Adjusting containers limiters position
Semi-automatic BOV Crimping Machine Z-2312 was equipped with position limiters placed on
device footing. Correct placement of limiters is obtained when container and working head are in
coaxial position.
To regulate position of limiters proceeds as follows:
By using hex key size 5 unscrew blocking screws M6 on limiters and move limiters
completely backwards - Fig. 12, pos. 1;
Place a container directly under working head and check coaxiality of container and head -
Fig. 12, pos. 2. To set position precisely it is advised to lower down head height using
adjustment wheel on support stand;
Move limiters directly to container and block their position using M6 screws - Fig. 12, pos. 3.
Fig. 12. Regulation of containers limiters position
6.6. Regulation of pneumatic drives speed
Regulation of actuator movement speed is conducted with the help of non-return flow control
valves installed by its connections (GRLA valve type - Fig. 13) or, if there is not enough space, in its
direct proximity on pneumatic supply cables (GR valve type - Fig. 14). Regulation of valves should
always be conducted with air supply turned on.
Fig. 13. Non-return flow control valve GRLA type (mounted by actuator):
a) with socket for screwdriver, b) with thumb bolt
5 mm
a)
b)
Regulation bolt
Blocking nut