OPERATION AND MAINTENANCE MANUAL
Semi-automatic BOV Crimping Machine Z-2312
A0310.01.2312.905.1.EN
Page 30/33
additional crimping arbor will prevent the crimping jaws segments to decompose during
the dismount.
6.
Assembly the set composed of new crimping jaws, mounting sleeve and elastic clip
according to Fig. 16. Insert additional crimping arbor inside the jaws to facilitate the
process.
1. Crimping jaws
2. Elastic clip
3. Crimping jaws mounting sleeve
Fig. 16. Crimping jaws set
7.
Screw in (by hand) the set of jaws + mounting sleeve + elastic clip + additional arbor.
Remove the additional arbor and tighten the whole assembly using the lamellar key
9002.46.002.1 again.
8.
Install the inner sleeve [Fig. 9, pos. 6] with BOV valve sealing [Fig. 9, pos. 5]. Tighten it using
smaller end of special key 9312.46.000.0.
9.
After the replacement of crimping jaws, all parameters of crimping head need to be
re-adjusted maintaining following sequence:
a)
Adjustment the BOV valve sealing [Fig. 9, pos. 5] so that the sealing can hold the
valve properly during pre-gasifying (UTC filling). The adjustment is performed by
turning the inner adjustment sleeve [Fig. 9, pos. 6] using smaller end of special key
9312.46.000.0. The inner sleeve has notches cut on the bottom surface matching
the pins of key’s smaller end. Use BOV valve for reference during adjustment.
b)
Adjustment of crimp height. The adjustment is performed by turning the outer
adjustment sleeve [Fig. 9, pos. 7] using bigger end of special key 9312.46.000.0. The
outer sleeve has notches cut on the bottom surface matching the pins of key’s
bigger end.
c)
Adjustment of crimp diameter. The adjustment is performed by turning the
crimping jaws [Fig. 9, pos. 8] using lamellar key 9002.46.002.1
.
3
2
1
Summary of Contents for Z-2312
Page 36: ...PNEUMATIC DIAGRAMS...
Page 38: ...SPARE PARTS LIST WITH TECHNICAL DRAWINGS...
Page 44: ...ELECTRIC DIAGRAMS...
