ZETRON 025-9581M, Installation And Maintenance Manual

Page: 63 / 196

63
Serial Port Programming
12. ( Optional ) Entering a “ 4 ” at the top menu opens the Inputs menu. From this menu,
you can set which polarity is considered the active state for the sense input being
programmed. You can also set the debounce time used to filter state transitions for
each input. For more information on this menu and its options, see
“Inputs” Menu
on page 71.
When you have finished in this menu, type “ e ” to return to the top menu.
13. When you have finished programming the station unit, type “ e ” as many times as
necessary to return to the top menu, then type “ e ” one more time to exit the serial
programming mode.
14. Move switch SW1-8 back to the Off position and disconnect the serial cable from
the socket J1 on the transponder board. Close the unit.
“Station Configuration” Menu
This menu selection is found in the Main Menu. There are several different Station
Configuration Menus that can be displayed. The menu displayed depends on the Model
6203 current Communication Mode. This mode is also selected from within this menu.
Different Communication Modes require different parameters and only the parameters
that affect the selected mode are displayed. The mode that you are most likely to use is
shown in
Figure 13 .
Note The firmware in the Model 6203 is based on an earlier product that
also supported wireline connections. Please ignore any references
to wireline that appear in the menus. This mode is no longer
supported.