Motor and Drive System
Controller
30-35
30
6. Place new phase lead O-rings (x3) on the
phase leads.
7. Install proper phase leads onto the controller
terminals. The phase leads U1, V1, and W1 will
match the corresponding positions listed on
the label on the top of the controller.
8. Install terminal bolts (x3). Tool: 22mm 6-point
socket. Torque: 11lb-ft (15 Nm).
CAUTION:
Install the terminal bolts without
any thread locking compound.
CAUTION:
Install the terminal bolts without
any CP70 (or any type of insulating
lubricant/gel/paste).
Note: Phase lead W1 has to be torqued before
moving to the next step. It will be unaccessible
after the following step.
Note: Confirm that the phase leads are
positioned/clocked as shown on top of the
controller. Once the terminal bolts are
torqued, you will not be able to reposition/
re-clock the phase leads.
9. Place the busbar support on top of the
controller (using the locating pin and locating
hole).
10. Apply a thin film of CP70 to the terminal inside
the Radsock cups on the busbars.
Summary of Contents for SR/S
