Zeiss CIRRUS photo 600, Manual

Page: 33 / 106

Installation
000000-2121-813-GA-GB-050416
25
Installation
Notes on installation and use
WARNING - GENERAL HAZARDS
First-time operation, installation and relocation of the device are to be
carried out by Carl Zeiss Meditec authorized specialists only.
The device may not be stored or operated in ambient conditions other than
those prescribed (see section
Technical data
on page 54 and following).
The device must be set up so that the power cable can be disconnected
from the power supply quickly and without any supplementary means.
WARNING - RISK OF ELECTRIC SHOCK
Do not use additional extension cables or portable multiple sockets.
The electrical installation must conform to IEC 60364-7-710 or the
applicable national regulations. This includes the integration of a ground
fault circuit interrupter (GFCI).
To avert the risk of an electric shock, this device may only be connected to
a power supply with a protective ground conductor. To completely
disconnect from the power supply the device must be unplugged.
Ensure that the power supply plug is suitable and certified for the local
connection. Only power cables of the same type should be used if the cable
supplied needs to be replaced.
WARNING - FIRE HAZARD
The device is not suitable for operation in explosion risk areas (e.g.
combustible mixture of anesthetic, cleaning or disinfecting agents with air,
oxygen or nitrous oxide).
The electrical installation must conform to IEC 60364-7-710.
The data concerning power consumption on the type plate must be taken
into account in the selection of overcurrent protection.