Axio Imager 2
FIRST-TIME SET-UP
ZEISS
Installing and removing P&C reflector modules
01/2016
430000-7544-001
41
3.11
Installing and removing P&C reflector modules
Normally, the reflector turret is factory-equipped with P&C (Push&Click) reflector modules if requested by
the customer. However, the user can also change the equipment of these turrets.
The reflector turret is designed to
hold
a maximum of six or ten reflector modules, depending on the
model.
3.11.1
Installing a module
•
Fold up cover flap (Fig. 19/
4
) to the right on
reflector turret (Fig. 19/
3
) and unhinge it using
the handle (Fig. 19/
7
) on the left.
•
Turn the reflector turret until the desired
position (position ID labeled on reflector turret)
can be accessed in the mounting hole.
•
Holding it by the handles (Fig. 19/
5
) to the right
and left of the module, insert the module
(Fig. 19/
6
) obliquely from the bottom into the
upper spring clips (Fig. 19/
1
) on the reflector
turret.
•
Then press the bottom of the module until it
snaps securely into the lower spring clips
(Fig. 19/
2
) of the reflector turret as well.
3.11.2
Removing a module
•
Slightly tilting the module, release it first from the bottom spring clips and then from the top spring
clips. Remove it completely.
•
After having removed and installed the reflector modules, re-apply the cover flap and let it snap in.
•
Turn the reflector turret through three or five positions (10-position reflector turret) to swing the
newly installed module into the optical path.
•
After equipping the turret as desired, label the adhesive labels with the new filter combination and
affix them to the corresponding fields on the cover flap.
Fig. 19
Changing P&C reflector modules
