ZEISS
OPERATION
Axio Imager 2
Operating the motorized microscope via the touchscreen of the TFT display
128
430000-7544-001
01/2016
−
The DIC slider to be used can be chosen in
the following pop-up menu. If a motorized
condenser is utilized, the condenser disk will
automatically move to the correct condenser
position when the contrast method is
selected.
−
Via Catalog No.
button
The user must enter the Zeiss catalogue
number (XXXXXX-XXXX-XXX) to select an
objective.
To execute the configuration procedure,
press the
Save
button. To abort the
procedure, press the
Cancel
button.
When entering the 15-digit Zeiss
catalogue no., the prefixed six zeros or
the affixed seven zeros should not be
entered (after 123456 enter a hyphen
(-) or enter 1234-567 and press
OK
).
The missing zeros will be added
automatically.
If a nosepiece and objectives with automatic component detection have been selected as stand
equipment, objective configuration can be triggered by pressing the
Automatic detection
button. The
user does not then to make any further manual settings.
Manually edited objective positions will not be overwritten by Automatic Component Detection.
They must be entered manually as empty positions beforehand.
Once a new objective has been allocated, the relevant objective button on the
Microscope
turrets
page will show the magnification and immersion data of that objective.
Fig. 130
Allocating the DIC slider
Fig. 131
Configuring the objective via
reference number
