User Manual 3PH HYD5000-HYD20000-ZSS
Rev. 1.1 16/03/2021
Identification: MD-AL-GI-00
Rev. 1. of 16/03/2021 - Application: GID
128/138
11.2.
Ethernet adapter
11.2.1.
Installation
Installation must be carried out for all inverters compatible with the adapter. However, the procedure
is quicker and easier as there is no need to open the front cover of the inverter.
Proper operation of the device requires the presence of a modem correctly connected to the network
and in operation in order to achieve stable data transmission from the inverter to the server.
In order to monitor the inverter, the RS485 communication address must be set to 01 directly from the
display.
Installation tools:
Cross screwdriver
Ethernet adapter
Shielded network (Cat. 5 or Cat. 6) crimped with RJ45 connectors
1)
Switch off the inverter following the procedure described in this manual.
2)
Remove the cover for accessing the Wi-Fi/Eth connector on the bottom of the inverter by
unscrewing the two cross-head screws (a), or by unscrewing the cover (b), depending on the
inverter model, as shown in the figure.
(a)
(b)
Figure 109 – Port of the Ethernet adapter
3)
Remove the ring nut and the waterproof cable gland from the adapter to allow the network cable
to pass through; then insert the network cable network into the appropriate port on the inside of
the adapter and tighten the ring nut and cable gland to ensure a stable connection.
