650 MDS
Section 3
YSI, Incorporated Drinking Water Monitoring Systems Operations Manual
3-10
To use the device with an American or Japanese vehicle, slide the adapter ring off of the plug. To use the
device with a European vehicle, leave the adapter ring on the plug and position it so the slots on the ring
line up with the plug’s spring clips. To begin charging your battery pack, first plug the barrel connector of
the cigarette lighter charger into the mating end of the 6116 adapter cable. Then attach the MS-8 end of the
6116 adapter cable to the 650. Finally, plug the other end of the cigarette lighter charger into the vehicle’s
lighter socket.
The 616 cigarette lighter charger contains a 2-ampere fast-blow type fuse. If the power cord stops working
properly, unscrew the adapter’s cap, remove the tip, and then pull out and check the fuse. See diagram
above to remove the fuse. If the fuse is blown or you are unsure, replace it with a new 2-amp fast-blow
fuse that is available at electronics stores such as Radio Shack. Reassemble the adapter and securely screw
the cap back onto the adapter body.
After you have installed batteries or the rechargeable battery pack into your 650, you are ready to proceed
to the next sections.
3.2.6 TURNING THE
3.2.6 TURNING THE
3.2.6 TURNING THE
3.2.6 TURNING THE INSTRUMENT ON
INSTRUMENT ON
INSTRUMENT ON
INSTRUMENT ON
Turn the instrument on by pressing and releasing the on/off
button on the top left of the instrument keypad.
The following screen should be displayed.
Main Display
Status Bar
