9-13
IM 760201-01E
Storing Numeric Data and Saving Stored Numeric Data
3
2
1
4
5
6
7
8
9
10
11
12
13
14
App
Index
9.6 Storing Numeric Data
Procedure
If you are storing numeric data for the first time after turning the power switch on,
proceed to step 1. If you have stored numeric data in the past, proceed to step 3 to
initialize storage.
Starting the Storage Operation
1.
Press
STORE
. Depending on the storage mode (see section 9.2 for details),
storage will start under one of the following conditions:
• In Manual Mode
Storage starts immediately. The store key lights, and “Store:Start” appears in
the upper left of the screen.
• In Real Time Mode
The WT500 enters into a storage-ready state. The STORE key blinks, and
“Store:Ready” appears in the upper left of the screen. Storage starts at the
scheduled storage start time. The store key lights, and “Store:Start” appears
in the upper left of the screen.
• In Integration Synchronization (Integ Sync) Mode
The WT500 enters into a storage-ready state. The STORE key blinks, and
“Store:Ready” appears in the upper left of the screen. Storage starts when
integration starts. The store key lights, and “Store:Start” appears in the upper
left of the screen.
Manually Stopping the Storage Operation
2.
After starting storage, you can press
STORE
again to stop storage. The STORE
key light turns off.
Automatically Stopping the Storage Operation
2.
Depending on the storage mode, storage will stop, and the STORE key light will
turn off under one of the following conditions:
• In Manual Mode
Storage will stop when the store count is reached, when there is no more
available memory, or when the maximum amount of storable data (1 GB) has
been stored. “Store:Stop” appears in the upper left of the screen.
• In Real Time Mode
Storage will stop when the store count has been reached, at the scheduled
storage end time, or when the maximum amount of storable data has been
stored. “Store:Stop” appears in the upper left of the screen.
• In Integration Synchronization Mode
Storage will stop when the store count has been reached, when integration
stops, or when the maximum amount of storable data has been stored. “Store:
Stop” appears in the upper left of the screen.
Resetting the Storage Operation
3.
After storage has stopped, press
STORE
again.
The storage condition indicator is cleared.
Note
Stored files are retained when you reset a storage operation.
