YOKOGAWA WT110, User Manual

Page: 99 / 204

IM 253401-01E
10-17
10
Using External In / Output
10.9 Outputting to an External Plotter / Printer
Relevant Keys
SCALING AVG FILTER STORE RECALL HARMONICS
SAMPLE
V OVER
A OVER
MODE
RMS
V MEAN
DC
A
B
C
hour
hour
min
min sec
V VA
m
A k
var
M W
TIME
V PF
m
A k deg
M W %
FUNCTION
AUTO AUTO
MODE
1
Φ
3W
V Hz
m
A k h
M W
TRIG
V RANGE A RANGE HOLD
ENTER
INTEGRATOR
START
HARMONICS MEMORY INTEG SET
STOP RESET
REMOTE
INTERFACE OUTPUT
LOCAL
SETUP
h
SHIFT
WIRING
3
Φ
3W
3
Φ
4W 3V3A
ELEMENT
1 2 3
FUNCTION ELEMENT
1 2 3
FUNCTION ELEMENT
1 2 3
*Shows the operation panel of the WT130. For the differences
between WT110 and WT130, refer to section 2.2, page 2-2, 2-3
Displays
relevant
keys and
indicator
Operating Procedure
1.
SHIFT
LOCAL
INTERFACE
ENTER
3.
2.
ENTER
5.
4.
Communication settings depend on your communication interface.
Refer to Ch.11 or 12 for the menu.
This menu only appears in case of version 1.11 and later.
For instruments earlier than version 1.11, the setting ends at step 3.
PCL is displayed on WT110/WT130 with version 2.21 or later.
Setting the output Mode
(Display C)
Communication setting
*1
End End
*2
Setting plotter or printer
(Display C)
•Setting the Output Mode If the communication interface
that you purchased is an
RS-232-C, the menu proceeds
to the "Selecting handshaking
method" menu of page 12-4.
Set the relevant parameters
such as the handshaking
method, format, and baud rate,
then press the
ENTER key to
complete the settings. If the
communication interface is a
GPIB, the procedure ends at
step 5.
*1
*2
*3
*3
• Perform operations following the thick line in the below menu.
• Press the ENTER key to confirm the selection or setting.
• When you want to leave the current menu during operation, press the key described
under step 1. The confirmed settings made until that point will be kept.
SHIFT
SETUP
OUTPUT
ENTER
3.
(Display C)
(Display C)
2.
ENTER
5.
4.
Setting the output items
(Display C)
ENTER
9.
End
6.
6.
Sets the A column
7.
Moves to the B column
8.
Select from 1 to 3
A B
SHIFT
1.
• Setting the Output Items
SHIFT
SETUP
OUTPUT
ENTER
3.
Activating the output
(Display C)
2.
End
1.
• Activating the Output
Selecting data or set-up
parameters
(Display C)
ENTER
5.
End
4.
*1
This menu only appears in case of version 1.11 and higher.
For instruments lower than version 1.11, the setting ends at step 3.
*
1