IM 253401-01E
11-8
Output Format
The output format depends on the selected output items which can be selected by the “OH”
command.
In case of voltage and current
All computed values of
the 1st to 50th order
,
Terminator
Analysis value for
fundamental (1st order)
,
Terminator
END
Terminator
Line 1
Line 2
Line 3
Line 51
Line 52
Analysis value for 50th
harmonic
,
Terminator
Analysis value for 2nd
harmonic
,
Terminator
Frequency
Relative harmonic content
for 2nd harmonic
Relative harmonic content
for 50th harmonic
harmonic distortion
In case of active power
All computed values of
the 1st to 50th order
,
Terminator
Analysis value for
fundamental (1st order)
,
Terminator
END
Terminator
Line 1
Line 2
Line 3
Line 51
Line 52
Analysis value for
50th harmonic
,
Terminator
Analysis value for
2nd harmonic
,
Terminator
Frequency
Relative harmonic content
for 2nd harmonic
Relative harmonic content
for 50th harmonic
Power factor
In case of phase angle
,
Terminator
END
Terminator
Line 1
Line 2
Line 3
Line 50
Line 51
Phase angle between
fundamentals
of voltage and current
Frequency
Phase angle between
fundamental and
2nd harmonic of current
,
Terminator
Phase angle between
fundamental and 2nd
harmonic of voltage
,
Terminator
Phase angle between
fundamental and
3rd harmonic of voltage
,
Terminator
Phase angle between
fundamental and
50th harmonic of voltage
Phase angle between
fundamental and
3rd harmonic of current
Phase angle between
fundamental and
50th harmonic of current
In case of ALL setting
The data will be output in the sequence voltage
→
current
→
active power
→
phase angle
→
END <terminator>
- The output format of each item is as described for each item above;
- The END line is not output for each item, but after finishing the entire output operation.
Output Format of Set-up Parameters and Error Codes
Refer to the explanations and examples of the “OS” or the “OE” commands described in
Appendix 1.1.
11.4 Output Format for Normal Measured/Computed Data, Harmonic Analysis Data, Set-up Parameters and Error Codes
