Yealink CPE80, Administrator'S Manual

Page: 64 / 321

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
48
Endpoint Initialization
Once you have power on the endpoint, it will begin its initialization process.
During the initialization process, the following events take place:
Loading the ROM file
The ROM file sits in the flash memory of the endpoint. Endpoints come from the factory with a
ROM file preloaded. During initialization, endpoints run a bootstrap loader that loads and
executes the ROM file.
Configuring the VLAN
If the endpoint is connected to a switch, the switch will notify the endpoint about the VLAN
information defined on the switch.
Querying the DHCP (Dynamic Host Configuration Protocol) Server
The endpoint is capable of querying a DHCP server. DHCP is enabled on the endpoint by default.
The following network settings can be obtained from the DHCP server during initialization:

IP Address

Subnet Mask

Gateway

Primary DNS (Domain Name Server)

Secondary DNS
You need to configure the network settings of the endpoint manually if any of them are not
provided by the DHCP server. For more information on configuring network settings manually,
refer to
Configuring Network Settings Manually on page 61 .
Endpoint Startup
After the initializing process, the endpoint will complete startup by cycling the following steps:
1.
The LED indicator on the VC110 all-in-one unit illuminates solid green.
2.
The display device displays the boot up screen.
3.
The camera pans to the middle position automatically.
4.
The display device displays the setup wizard (when you first start up, or reset the endpoint,
the display device will display the setup wizard)
For more information on how to complete the setup wizard, refer to Setup Wizard on page
49 .
5.
After completing the setup wizard, the display device displays the main screen.
The main screen displays the following:

Time and date