Yealink CPE80, Administrator'S Manual

Page: 90 / 321

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
74
To configure LLDP via the remote control:
1.
Select
Menu
->
Advanced
(default password: 0000) ->
Advanced Network
.
2.
In the
LLDP
block, check the
Active
checkbox.
3.
Enter the desired value in the
Packet Interval (1-3600s)
field.
4.
Press the
Save
soft key to accept the change.
The display device prompts “Reboot now?”.
5.
Select
OK
to reboot the endpoint immediately.
Manual Configuration for VLAN
VLAN is disabled on endpoints by default. You can configure VLAN manually. Before configuring
VLAN on the endpoints, you need to obtain the VLAN ID from your network administrator.
Parameters of manual VLAN on the endpoint are described below.
Parameter Description Configuration Method
Internet
Port
->
Active
Enables or disables VLAN for the
Internet (WAN) port.
Default:
Disabled
Note
: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
VID(1-4094)
Configures VLAN ID for the Internet
(WAN) port.
Default:
1
Note
: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
Priority
Configures VLAN priority for the
Internet (WAN) port.
Valid values:
0-7
7 is the highest priority, 0 is the
lowest priority.
Default:
0
Note
: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
To configure VLAN for Internet port via web user interface:
1.
Click on
Network
->
Advanced
.