YATO YT-09513, Original Instructions Manual

Page: 17 / 108

GB
17
O R I G I N A L I N S T R U C T I O N S
tool may be a cause of injuries. All repair and replacement of the elements of the tool must be performed by
quali fi ed personnel in an authorized repair shop.
Defect Possible solution
The rotation of the tool is
too slow or it is impossible
to start the tool
Introduce a small amount of WD-40 through the air inlet. Start the tool for a couple of seconds.
It is possible that the blades adhere to the rotor. Start the tool for approximately 30 seconds.
Lubricate to tool with a small amount of oil. Attention! Excessive amount of oil may cause a
drop in the power of the tool. In such a case, clean the power transmission.
The tool starts but then
slows down
The compressor does not provide an appropriate fl ow of the air. The tool starts with the air
collected in the tank of the compressor. While the tank is being emptied, the compressor
cannot follow up re fi lling the tank. Connect the tool to a more e ffi cient compressor.
Insu ffi cient power
Make sure the inside diameter of the installed hoses is not lower than 3/8”. Check the regulator
of pressure – pressure must be set at the maximum value. Make sure the tool is properly
cleaned and lubricated. If there are no results, send the tool for repair.
Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protec-
tions must be cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth
without any chemical substances or cleaning liquids. Tools and handles must be cleansed with a clean cloth.
Worn tools are recyclable waste – it is prohibited to dispose of them throwing them away along with domestic
waste, since the tools contain substances that are harmful for people and the environment! We ask for your
active assistance in economic management of natural resources and protection of the natural environment by
sending the tools to a worn tools disposal point. In order to reduce the quantity of waste that is disposed if, it
is necessary to recycle them.