The modules at the right side of the CPU at the standard bus are configured with the fol-
lowing approach:
1.
Start the hardware configurator from Siemens with a new project and insert a profile
rail from the hardware catalog.
2.
Place the corresponding Siemens CPU at slot 2.
3.
Include your System 300V modules at the standard bus in the plugged sequence
starting with slot 4.
4.
Parameterize the CPU res. the modules where appropriate. The parameter window
opens by a double click on the according module.
5.
To extend the bus you may use the IM 360 from Siemens where you can connect
up to 3 further extension racks via the IM 361. Bus extensions are always placed at
slot 3.
6.
Save your project.
To extend the bus you may use the IM 360 from Siemens where you can
connect up to 3 further extension racks via the IM 361. Bus extensions
are always placed at slot 3.
The slot assignment of the SPEED-Bus modules and the parameterization of the in-/
output periphery happens via a virtual PROFIBUS DP master system. For this, place as
last module a DP master (342-5DA02 V5.0) with master system. For the employment of
the System 300S modules at the SPEED-Bus the inclusion of the System 300S modules
into the hardware catalog via the GSD-file speedbus.gsd from VIPA is required.
After the installation of the speedbus.gsd you may locate under
Profibus DP / Additional
field devices / I/O / VIPA_SPEEDbus
the DP slave system vipa_speedbus.
Now include for the CPU and every module at the SPEED-Bus a slave system
"vipa_speedbus". Set as PROFIBUS address the slot number (100...110) of the module
and place the according module from the hardware catalog of VIPA_speedbus to slot 0 of
the slave system.
Project engineering of the
modules at the standard
bus
Project engineering of all
SPEED-Bus modules in a
virtual master system
VIPA System 300S
Digital Modules FAST - SPEED-Bus
Project engineering > Steps of project engineering
HB140 | SM-DIO | | en | Rev. 16-43
88
