STARTING THE ENGINE
Before Starting the Engine
1. Open the seacock.
2. Open the fuel tank cock.
3. Set the control lever on the control head
(Figure 1, (2)) in N (neutral)
(Figure 1, (1)) position.
0002056
2
1
Figure 1
4. Turn on the battery switch and the start-
up / version screen (Figure 2) pops up
on the display. Then, the screen will
change to the engine data display mode.
i5601E
LY3
PORT
Multi-Function Display
Electronic
Controls
Ver 3.00P
COPYRIGHT 2006 TELEFLEX, INC.
0002057
i5601E
Figure 2
5. Press the Eng ON (Figure 3, (1)) switch
and the following changes occur:
Start
Eng ON
OFF
Emergency
Stop
Sub throttle active
Sub throttle
0002058
(1)
Figure 3
• The needle appears in the engine
tachometer on the display.
0
1
2
3
4
WTR TEMP
X1000
RPM
PSi
8 4
2615
0
100
100
250
1 1 4
Fa h
SINGLE
OIL PRES
0002060
Figure 4
To Start the Engine
To start the engine, press Start (upper half)
of Eng ON switch (Figure 3, (1)).
NOTICE: Never hold the key in the start
position for longer than 15 seconds or the
starter motor will overheat.
ENGINE OPERATION
6LY3 LDC Operation Manual
35
© 2008 Yanmar Marine International