Yamaha XV19SW 2006, Service Manual

Page: 73 / 145

CABLE ROUTING
2-48
1. Main switch lead
2. Right handlebar switch lead
3. Wire harness
4. Left handlebar switch lead
5. Air temperature sensor lead
6. Front left turn signal/position light lead
7. Headlight lead
8. Front right turn signal/position light lead
9. Headlight coupler (high beam)
10. Headlight coupler (low beam)
11. Air temperature sensor
12. Main switch
A. View with headlight lens unit removed.
B. Place the joint coupler behind the leads.
C. Place the sections of the handlebar switch leads
that are not covered by their protective sleeves in
the rear of the headlight housing.
D. Fasten the headlight leads, front turn
signal/position light leads, and accessory light lead
with the holders along the side of the headlight
housing.
E. Place the headlight leads, front turn signal/position
light leads, and accessory light lead near the base
of the holder.
F. 30 mm (1.18 in)
G. View from rear of headlight lens unit
H. Less than 20 mm (0.79 in). Fasten the headlight
lead (low beam) with the holder, making sure to
fasten the protective sleeve of the lead, not the lead
itself.
I. Route the headlight lead (high beam) between the
headlight coupler (low beam) and the stay.
J. Route the headlight lead (high beam) behind the
headlight lead (low beam).
K. Secure the plastic band by inserting the projection
on the band into the hole in the headlight housing.
L. Face the end of the plastic band downward.