Yamaha XV19SW 2006, Service Manual

Page: 130 / 145

GENERAL CHASSIS
4-5
ET1D71041
REMOVING THE BACKREST
1. Remove:
• Backrest
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Open the sidebag lids.
b. Insert the key “1” into the backrest lock, turn
it counterclockwise, and then remove the
key.
c. Pull the lever “1” on each side of the backrest
upward.
d. While holding the levers in the upward posi-
tion, lift the backrest upward and remove it by
pulling it to the rear.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
ET1D71046
ASSEMBLING THE BACKREST
1. Install:
• Backrest lock “1”
NOTE:
Align the projection “a” on the lock “1” with the
slot “b” in the left backrest lower bracket “2”.
2. Install:
• Backrest lower brackets “1”
• Backrest upper bracket “2”
• Backrest plate
NOTE:
Before tightening the bolts “3” to specification,
temporarily install the backrest lower brackets
on the backrest holders, making sure not to push
down on the rear of the brackets. The lower bolts
cannot be tightened when the backrest lower
brackets are installed completely.
ET1D71042
INSTALLING THE BACKREST
1. Install:
• Backrest
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Fit the slot “a” on each backrest bracket (left
and right side) into the groove of its holder “b”.
CAUTION:
EC1D71026
Be careful not to scratch the rear fender
when fitting the slot into the groove.
2. Unlock.
2
1
1
a
1
2
b
3
1
1
2