Yamaha TMAX XP500F 2015, Service Manual, Page: 15 / 478

FEATURES
1-6
NOTICE
ECA20730
Do not continue to operate the engine if it is
overheating.
Oil change indicator “Oil”
This indicator flashes at the initial 1000 km (600
mi), then at 5000 km (3000 mi) and every 5000
km (3000 mi) thereafter to indicate that the en-
gine oil should be changed.
After changing the engine oil, reset the oil
change indicator. To reset the oil change indica-
tor, select it by pushing the “SELECT” button un-
til “Oil Trip” is displayed, and then push the
“SELECT” button at least one second. When
pushing the “SELECT” button, “Oil Trip” starts
flashing. While “Oil Trip” is flashing, push the
“SELECT” button for at least three seconds.
If the engine oil is changed before the oil change
indicator “Oil” flashes (i.e. before the periodic oil
change interval has been reached), the indicator
“Oil” must be reset after the oil change for the
next periodic oil change to be indicated at the
correct time.
The electrical circuit of the indicator can be
checked according to the following procedure.
1. Set the engine stop switch to “
” and turn
the power of the vehicle on.
2. Check that the oil change indicator comes on
for a few seconds and then goes off.
3. If the oil change indicator does not come on,
check the electrical circuit.
(Refer to “SIGNALING SYSTEM” on page
8-19)
V-belt replacement indicator “V-Belt”
This indicator flashes every 20000 km (12500
mi) when the V-belt needs to be replaced.
After changing the V-belt, reset the V-belt re-
placement indicator. To reset the V-belt replace-
ment indicator, select it by pushing the
“SELECT” button until “V-Belt Trip” is displayed,
and then push the “SELECT” button at least one
second. When pushing the “SELECT” button,
“V-Belt Trip” starts flashing. While “V-Belt Trip” is
flashing, push the “SELECT” button for at least
three seconds.
If the V-belt is changed before the V-belt re-
placement indicator “V-Belt” flashes (i.e. before
the periodic V-belt change interval has been
reached), the indicator “V-Belt” must be reset af-
ter the V-belt change for the next periodic V-belt
change to be indicated at the correct time.
The electrical circuit of the indicator can be
checked according to the following procedure.
1. Turn the vehicle on and make sure that the
engine stop switch is set to “ ”.
2. Check that the V-belt replacement indicator
comes on for a few seconds and then goes
off.
3. If the V-belt replacement indicator does not
come on, check the electrical circuit.
(Refer to “SIGNALING SYSTEM” on page
8-19)
1. Oil change indicator “Oil”
1
1. V-belt replacement indicator “V-Belt”
1