Yamaha R1 Series 2015, Service Manual, Page: 688 / 704

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
(ECU)
9-9
61 Malfunction history code dis-
play
—
•
No history 00
•
History exists Fault codes 8–99
•
(If more than one code
number is detected, the
display alternates every
two seconds to show all the
detected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
62 Malfunction history code era-
sure
•
No history 00 —
•
History exists
•
Displays the total number
of malfunctions, including
the current malfunction,
that have occurred since
the history was last erased.
(For example, if there have
been three malfunctions,
“03” is displayed.)
To erase the history, set the
start/engine stop switch from
“ ” to “ ”.
63 Malfunction code reinstate-
ment (for fault code No. 24,
40, 42, 68, 69 only)
•
No malfunction code 00 —
•
Malfunction code exists Fault code 24, 40, 42, 68, 69
•
(If more than one code
number is detected, the
display alternates every
two seconds to show all the
detected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
To reinstate, set the
start/engine stop switch from
“ ” to “ ”.
67 ISC (Idle Speed Control)
learning condition display
ISC (Idle Speed Control)
learning data erasure
00
ISC (Idle Speed Control)
learning data has been
erased.
01
It is not necessary to erase
the ISC (Idle Speed Control)
learning data.
02
It is necessary to erase the
ISC (Idle Speed Control)
learning data.
To erase the ISC (Idle Speed
Control) learning data, set
the start/engine stop switch
from “ ” to “ ” 3 times in 5
seconds.
70 Control number 0–254 [-] —
86 Shift switch Check the switch condition
by operating the shift pedal.
•
Shift pedal up position ON
•
Other position than the shift
pedal up position
OFF
Diagnostic
code No.
Item Meter display Procedure