Yamaha R1 Series 2015, Service Manual

Page: 143 / 704

CABLE ROUTING
2-68
1. Coolant temperature sensor coupler
2. Primary injector #4
3. Primary injector #3
4. Plastic locking tie
5. O
2
sensor lead
6. Neutral switch lead
7. Fuel pump lead
8. Engine ground lead
9. Starter motor lead
10.Primary injector #2
11.Primary injector #1
12.Frame
13.Round terminal
14.Combination terminal
A. Route the injector lead under the injector
joint.
B. Fasten the wire harness and fuel rail with the
plastic locking tie. Point the end of the plastic
locking tie downward. Do not cut off the
excess end of the plastic locking tie.
C. To O
2
sensor
D. To fuel pump
E. Insert the wire harness clamp into the frame
hole.
F. For YZF-R1M
G. Fasten the primary injector #4 lead and rear
shock absorber assembly stepping motor
lead to the fuel rail with the plastic locking tie.
Point the end of the plastic locking tie down-
ward. Do not cut off the excess end of the
plastic locking tie.
H. Connect the rear shock absorber assembly
stepping motor leads according to those with
identification tape (yellow) and those without
identification tape, and then cover the coupler
with the coupler cover.
I. Fasten the bottom side of the brake hose and
rear shock absorber assembly stepping
motor leads with the plastic locking tie. Posi-
tion the plastic locking tie between the front of
the frame and rear end of the coupler cover.
Point the end of the plastic locking tie down-
ward. Do not cut off the excess end of the
plastic locking tie.
J. To rear shock absorber assembly
K. Fasten the engine ground leads with the bolt
so that the crimped section of the terminal is
facing upward.