Yamaha R1 Series 2015, Service Manual

Page: 127 / 704

CABLE ROUTING
2-52
1. Clutch cable
2. Immobilizer unit lead
3. Intake solenoid vacuum hose
4. Horn
5. Steering damper solenoid lead
6. Front brake hose
7. Throttle cable (decelerator cable)
8. Throttle cable (accelerator cable)
9. Left handlebar switch lead
10.Main switch lead
11.Right handlebar switch lead
12.Front fork stepping motor sub-lead (right)
13.Front fork stepping motor sub-lead (left)
14.Clamp
15.Sub-wire harness
A. Make sure that each lead is not overlapped.
B. Connect the immobilizer unit lead above the
cylinder head cover.
C. To horn
D. To front wheel sensor
E. Route the left handlebar switch lead over the
main switch lead and right handlebar switch
lead.
F. Route the right handlebar switch lead to the
rear of the main switch lead.
G. For YZF-R1M
H. The front fork stepping motor sub-lead (right)
has the corrugated tube installed at the base
of the area where the sub-wire harness
branches out.
I. Route the front fork stepping motor sub-lead
(left) to the front of the clutch cable.
J. Route the front fork stepping motor sub-lead
(left) over the left handlebar switch lead, right
handlebar switch lead, and main switch lead.
K. Route the front fork stepping motor sub-lead
(right) over the throttle cables.
L. Fasten the front fork stepping motor sub-lead
(right) at the lower edge of the black tape,
and the brake fluid reservoir hose at the
straight section with the clamp. Face the
opening of the clamp downward.
M. Connect the front fork stepping motor cou-
pler, and then slide the waterproof cover over
until it contacts the front fork cap bolt.
N. Route the front fork stepping motor sub-lead
(left) above the leads and in front of the vehi-
cle, and then connect it to the front fork cap
bolt.
O. Route the sub-wire harness to the rear of the
left handlebar switch lead and main switch
lead.