Yamaha R1 Series 2015, Service Manual

Page: 135 / 704

CABLE ROUTING
2-60
1. Secondary injector lead
2. Throttle position sensor coupler
3. ECU (engine control unit) coupler
4. Engine ground lead
5. Starter motor lead
6. Gear position sensor lead
7. Fuel tank drain hose
8. Fuel tank breather hose
9. Sidestand switch lead
10.O
2
sensor lead (left)
11.Oil pressure switch lead
12.Clamp
13.Wire harness
14.Frame
15.Thermostat assembly
16.Stator coil assembly lead
17.Plastic locking tie
18.Oil pressure switch connector
19.Sidestand switch coupler (black)
20.O
2
sensor coupler
21.Shift switch coupler (white)
22.Crankshaft position sensor coupler
23.Stator coil coupler
24.Shift switch lead
A. To secondary injector
B. Route the fuel tank drain hose through the
guide of the cover and position it in front of
the fuel tank breather hose. Align the paint
mark on the fuel tank drain hose to the guide
area of the cover.
C. Match the length of the fuel tank breather
hose coming out of the guide to the length of
the fuel tank drain hose.
D. Insert the clamp into the frame hole.
E. Fasten the wire harness with the clamp. Face
the buckle of the clamp upward, and then cut
off the excess end of the tie to 5 mm (0.2 in)
or less.
F. Fasten the straight portion of the thermostat
assembly and stator coil assembly lead with
the plastic locking tie. Point the end of the
plastic locking tie rearward and diagonally
downward. Do not cut off the excess end of
the plastic locking tie.
G. The oil pressure switch connector, sidestand
switch coupler, shift switch coupler, and O
2
sensor coupler may be positioned in any
order.
H. Place the coupler cover to the rear of the cou-
pler cover (stator coil side).
I. The stator coil coupler and crankshaft posi-
tion sensor coupler may be positioned in any
order.
J. Position the coupler cover (stator coil coupler,
crankshaft position sensor coupler) to the
inside of the thermostat assembly as shown
in the illustration.
K. The sidestand switch lead, O
2
sensor lead,
oil pressure switch lead and shift switch lead
may be routed in any order.
L. Fasten the sidestand switch lead, O
2
sensor
lead, oil pressure switch lead, shift switch
lead with the clamp. Install the clamp
between the coupler cover and drive sprocket
cover. The opening of the clamp may be fac-
ing in any direction.
M. The oil pressure switch lead, sidestand
switch lead and left O
2
sensor lead may be
routed in any order.
N. The left O
2
sensor lead and oil pressure
switch lead may be routed in any order.
O. Fasten the sidestand switch lead, left O
2
sen-
sor lead and oil pressure switch lead with the
clamp.