Yamaha R1 Series 2015, Service Manual, Page: 42 / 704

FEATURES
1-33
to “Unit” on page 1-41.)
Tachometer
The tachometer shows the engine speed, as
measured by the rotational velocity of the crank-
shaft, in revolutions per minute (r/min). When
the vehicle is first powered on, the tachometer
will sweep across the r/min range and then re-
turn to zero.
TIP
• In TRACK MODE, the tachometer starts at
8000 r/min.
• In STREET MODE, the tachometer can be col-
or-adjusted and has a revolution peak hold in-
dicator which can be turned on or off.
NOTICE
ECA19660
Do not operate the engine in the tachometer
red zone.
Information display
This section of the main screen is used to show
additional riding related information such as air
and coolant temperature readings, tripmeters,
and fuel consumption statistics. The information
display items can be set into four groups via the
MENU screen.
The information display items are:
A.TEMP: air temperature
C.TEMP: coolant temperature
TRIP-1: tripmeter 1
TRIP-2: tripmeter 2
F-TRIP: fuel tripmeter
ODO: odometer
FUEL CON: the amount of fuel consumed
FUEL AVG: average fuel consumption
CRNT FUEL: current fuel consumption
TIP
•
F-TRIP appears automatically when the fuel
tank reserve level has been reached and be-
gins recording distance travelled from that
point.
•
After refueling and travelling some distance, F-
TRIP will automatically disappear.
•
In TRACK MODE, information display items
FASTEST (fastest lap time) and AVERAGE
(average lap time) are also available.
TRIP-1, TRIP-2, F-TRIP, FUEL CON, and FUEL
AVE items can be individually reset.
[To reset information display items]
1. Use the wheel switch to scroll through the dis-
play items until the item you want to reset ap-
pears.
2. Short push the wheel switch and the item will
flash for five seconds. (For STREET MODE,
if both items are resettable items, the top item
will flash first. Scroll down to select the bot-
tom item.)
3. While the item is flashing, press and hold the
wheel switch for one second.
Transmission gear display
This shows which gear the transmission is in.
This model has 6 gears and a neutral position.
The neutral position is indicated by the neutral
indicator light “ ” and by the transmission gear
display “ ”.
Front brake pressure indicator
This shows how much braking power is being
applied to the front brakes.
Acceleration indicator
This shows the vehicle’s forward acceleration
and deceleration forces.
Revolution peak hold indicator
This small bar momentarily appears within the
tachometer to mark the most recent peak r/min
speed of the engine.
YRC items MODE/PWR/TCS/SCS
The current MODE (YRC mode) and its related
PWR, TCS and SCS settings are shown here.
The individual settings for YRC items PWR,
TCS, SCS, LCS, QSS and LIF can be organized
into four groups and set independently for each
group. These groups of settings are the YRC
modes MODE-A, MODE-B, MODE-C, and
MODE-D. Use the mode switch to change YRC
modes or make YRC item setting changes from
the main screen.
TIP
The YRC modes come preset from the factory
for different riding conditions. When using the
factory presets, the suggested YRC modes are
as follows.
•
MODE-A is suitable for track riding.
• MODE-B is a softer track-riding setting.
•
MODE-C is suitable for street riding.
• MODE-D is suitable for touring or rainy weath-
er.
WARNING
EWA18210
Stop the vehicle before making any setting
changes. Changing settings while riding can
distract the operator and increase the risk of
an accident.
[To change YRC modes or make setting
changes]
1. Push the mode switch center button to scroll