Yamaha LS9 Editor, Owner'S Manual

Page: 210 / 290

210
Using cascade connections
LS9-16/32 Owner’s Manual
1
In the DISPLAY ACCESS section, press the
[SETUP] key repeatedly to access the SYS-
TEM SETUP screen.
1
CASCADE OUT button
2
In the MIXER SETUP field located at the
lower part of the SYSTEM SETUP screen,
move the cursor to the CASCADE OUT but-
ton and press the [ENTER] key.
The CASCADE OUT PATCH popup window will
appear. This window contains the following items.
1 Port select popup buttons
These buttons access an OUTPUT PORT SELECT
popup window where you can select the output port
for each bus.
B CASCADE LINK PORT field
When using the Cascade Link function, this specifies
the port by which control signals will be transmitted
and received between the two LS9 consoles.
C CASCADE COMM LINK field
Here you can select the parameters and events that will
be linked by the Cascade Link function.
3
Move the cursor to the port select popup
button for the bus whose port you want to
assign, and press the [ENTER] key.
The OUTPUT PORT SELECT popup window will
appear.
[ OUTPUT PORT SELECT popup window for
the LS9-32 ]
[ OUTPUT PORT SELECT popup window for
the LS9-16 ]
This popup window contains the following items.
1
Port select buttons
These buttons select the output port for the selected
bus.
B Slot select tabs (LS9-32 only)
These tabs select slots 1/2.
4
Use the port select buttons {slot select tabs
and port select buttons} to select an output
port, move the cursor to the CLOSE button
and press the [ENTER] key.
The port will be assigned to the bus you selected in
step 3.
5
Repeat steps 3 and 4 to assign output ports
to other buses.
Operations on the cascade slave
LS9
LS9-32
1
1
2
3
2
1
1
• You can’t assign two or more buses to the same output port. If
you select a bus to which a signal route has already been
assigned, the previous assignment will be cancelled.
NOTE