Manual Ozone Generating System
SMOevo
PLUS
Operation
Manual_SMOevoPLUS_eng_01.2019.doc
page 94 of 179
Injection System
(optional)
•
Start of the injection system.
Check for stable suction pressure on injector.
If not sufficient suction pressure develops on the injector within 1
min, the system stops and a fault message is generated.
Gas Flow
•
Start gas flow
The gas inlet valve opens, the flow control valve is activated.
Release signal to external device.
Periphery
(optional)
•
Start ozone destructor
The residual ozone destructor is started to extract the gas out of
the process.
Converter
(Ozone
Production)
•
Start Converter (Ozone Production)
The converter is started and the ozone generator is supplied
with energy. The ozone production starts.
The converter is not switched on if the converter button in the
screen System Settings is in position OFF. A manual purge
mode is carried out.
The converter switches on if the converter button in the screen
System Settings is in position ON.
•
Start of the cooling system (option).
The cooling water flow is initialized by the ozone generator.
Normal
Operation
•
The system in in normal operation.
Stop Sequence
Ozone System
•
Ozone system stops
The system is shut down via the automatic stop sequence.
Converter
(Ozone
Production)
•
Converter stops ozone production
The converter shuts down, ozone production is stopped.
Purging
Generator
•
System is purged ozone-free
The system is purged with feed gas in order to remove residual
ozone from the entire system.
The remaining purge time is shown in the message line.
Gas Flow
•
Gas flow stops
The flow control valve is closed.
The gas inlet valve is closed with a time delay.
External auxiliary stops after set Turn-off Delay.
Injection System
(optional)
•
The injection system stops (optional)
Gas introduction to process water is stopped.