Xerox Phaser 6360, Service Manual

Page: 147 / 564

Phaser 6300/6350/6360 Color Laser Printer Service Manual 3-47
Error Messages and Codes
Tray [3] [4] [5] Paper Is Low
An optional tray’s Low Paper Sensor indicates a Low Paper condition.
Applicable Status Codes:
Warning: Tray 3 is Low
Warning: Tray 4 is Low
Warning: Tray 5 is Low
Initial Actions:
■ Check that Tray 2 is at least half full of paper and free of obstructions.
■
Insert the tray and cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Fill the tray with paper.
Does the error occur if the tray is full? Go to Step 2. Complete
2
Check the following for evidence of fault
or damage:
■
Low Paper Sensor, PL3.3.7
■
Low Paper Actuator, PL3.3.14
Is there any damage?
Replace any
damaged parts. Go to Step 3.
3
Test the Low Paper Sensor.
Run the Service Diagnostics Tray 2 Low
Paper Sensor test.
Does the sensor and actuator function
properly? Replace the
Engine Control
Board
(page 8-106). Go to Step 4.
4
Check the Low Paper Sensor signal.
Is there +3.3 V between J473-1 <=>
J473-2?
Replace the Low
Paper Sensor
(page 8-32). Go to Step 5.
5
Check all pins on the FDR Harness
PL3.3.22 for continuity.
1. Disconnect P/J47 and P/J471.
2. Check continuity between J47 <=>
J471.
Replace the
Engine Control
Board
(page 8-106). Replace the
FDR Harness.