Xerox M20I - WorkCentre B/W Laser, System Administration Manual

Page: 48 / 218

Page 3-8 Xerox WorkCentre M20i System Administration Guide
NetWare
Using NetWare Utilities
Installation Procedure
There are three stages required to install the WorkCentre M20i on a NetWare network using
NetWare utilities:
¾
Network Communication Setup
This procedure will enable the WorkCentre M20i to communicate on the
NetWare network.
¾
NetWare Setup
This procedure is used to setup the network using NetWare utilities, for
example NWADMIN.
¾
Test Print
A print job should be submitted to ensure the WorkCentre M20i has been
installed and configured correctly.
If running NLSP, ensure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre M20i .
Network Communication Setup
At the WorkCentre M20i , perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the
WorkCentre M20i, refer to the Internet Services chapter for instructions.
¾
Ensure that the Basic TCP/IP settings have been configured (see “Network
Communication Setup” on page 2-8 ).
¾
Press the [Machine Status] button.
¾
1
2
3
¾
Press or until System
Admin Tools is displayed and
press [Enter].
¾
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]