Xerox EC70, User Manual

Page: 30 / 182

3. Configure the software.
Note: Instructions for installing the print drivers, utilities, and setting up the network are
provided in the System Administrator Guide. Locate the System Administrator Guide at
www.xerox.com/support . In the Search field, enter
Xerox Color EC70 Printer
, then
select the needed documentation.
PPhhyyssiiccaall C Coonnnneeccttiioonn
You can connect to the printer over a network. Connect to a functioning and dedicated fax telephone
line for the optional fax. Communication cables are not included with the printer, and ensure that
they are purchased separately.
To connect the printer physically:
1. Connect the power cable to the printer, and plug it into an electrical outlet.
2. Connect one end of a Category 5 or better Ethernet cable to the Ethernet port on the left side of
the printer. Connect the other end of the cable to your network drop.
3. If the fax option is installed, connect to a functioning telephone line using a standard RJ11 cable.
PPoow weerr O Oppttiioonnss
SSw wiittcchhiinngg O Onn tthhee PPrriinntteerr
The printer has three power switches:
• The Ground Fault Interrupt Switch is on the right side of the printer and near the power cord. At
installation and setup, ensure that this switch is in the On position.
• The Main Power Switch is located behind the front cover door. Verify that this switch is also in the
On Position. Do not use this switch to turn the printer on and off for general purposes.
30 Xerox ® EC70 Color Copier/Printer
User Guide
Getting Started