Xerox DocuPrint 96, Message Manual

Page: 103 / 358

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-25
Action None.
OS1322 Lead edge screen setting is nn
This message confirms that your EDGE (lead edge screen)
command parameters have been accepted or provides you with the
current settings if you have not entered new parameters.
Action None.
OS1323 Energy saver timeout is nn minutes
After entering the ENERGY command with a timeout parameter, this
message tells you that the value you have entered is accepted. If you
enter the ENERGY command with no parameters, the message tells
you the number of minutes currently set.
Action None.
OS1324 Energy Saver mode is disabled
The energy saver has been turned off.
Action None.
OS1325 IOT Attention steady light is xxx, flashing light is xxx
After entering the ATTENTION LIGHT command, this message tells
you whether the attention light(s) on your system‘s printer is enabled
or disabled, steady or flashing. If you enter the ATTENTION LIGHT
command with no new parameters, the message provides the
current settings.
Action None.
OS1326 Already in lockout mode
During service activities, the LOCKOUT mode has already been
initiated.
Action None.
OS1329 BINFULL criteria: n% ream threshold, n% boundary
After entering the BINFULL command with threshold and boundary
parameters, this message tells you that the values you have entered
are accepted. If you enter the BINFULL command with no
parameters, the message tells you the current settings.
Action None.
OS1330 XPS Accounting reset
XPS deletes all accounting files and recreates and initializes the
accounting recovery file.
Action Enter XPS command.