Xerox DocuPrint 96, Message Manual

Page: 149 / 358

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-71
OS2950 Software timing problem has caused a printer cycle-down
Input is being processed too rapidly for output to print. Output has
stopped.
Action Enter the CONTINUE O command to resume printing.
OS2960 Back up host to start of report or nn pages, whichever is less
The system is in a recovery mode after a software failure.
Action Resend either the number of pages stated or the entire report that
was printing at the time of the failure.
OS2980 Function not available in this LOGON class
The usage of the entered command was restricted at installation by
an RCU (Restrict Command Usage) command.
Action Obtain the correct password and log on at the required level. (Refer
to your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference
chapter on setting LPS parameters for additional information.)
OS2990 Use ‘PROBLEM’ at earliest opportunity.
The system has detected a hardware problem. (This message
occurs in conjunction with other messages describing problem.)
Printing can continue. However, if the condition is not corrected,
printing may stop eventually.
Action 1. Enter the PROBLEM command and record SAN codes
appearing on the display.
2. Contact your systems specialist or Xerox Customer Service.