Xerox DocuPrint 96, Message Manual

Page: 154 / 358

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-76 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS3010 Printer is warming up.
The printer is unable to respond to the entered command because
the fuser has cooled to below operating temperature.
Action 1. Wait for the fuser to reheat (the warmup light on the system
controller turns off).
2. Reenter the command.
A command was entered while the printer was in the power-
saver state or had just been powered on. The printer control
console displays one of the following:
BOTH TRAYS SET FOR _._X_._" PAPER
BOTH TRAYS SET FOR _X_MM PAPER
PRINTER IS WARMING UP
PRINTER IS WARMING UP. CHECK PAPER SUPPLY IN
TRAY 1
PRINTER IS WARMING UP. CHECK PAPER SUPPLY IN
TRAY 2.
PRINTER IS WARMING UP. PRESS i
PRINTER IS WARMING UP. OUTPUT TRAY 1 IS FULL
PRINTER IS WARMING UP. OUTPUT TRAY 2 IS FULL.
PRINTER IS WARMING UP. PAPER TRAY 1 IS EMPTY.
PRESS i
PRINTER IS WARMING UP. PAPER TRAY 2 IS EMPTY.
PRESS i
TRAY 1 IS SET FOR _._X_._" PAPER. TRAY 2 IS SET FOR
_._X_._" PAPER.
TRAY 1 IS SET FOR _X_MM PAPER. TRAY 2 IS SET FOR
_X_MM PAPER.
WARMING UP. BOTH PAPER TRAYS NOT SET FOR SAME
SIZE. PRESS i
3. Wait until READY TO PRINT appears on the printer control
console display.