Xerox DocuPrint 4850, Installation Planning Manual

Page: 100 / 226

Printer specifications and requirements
6-12 Installation Planning Guide
Clearance space requirements
The printer must be installed in a fixed location that provides the
following clearance space:
• 36 inches / 91.4 cm on all sides of each component
• 78 inches / 198 cm of vertical clearance throughout the entire
area
• 24 inches / 61 cm of exclusive operator area in front of each
component.
Shared space
It is best to provide the full amount of clearance space around
the hardware components. Your environment may require you to
use shared space between components, such as between the
printer and another Xerox printing system. You can share the 36-
inch / 91.4 cm clearance space around each component, as long
as you follow these rules:
• Space may be shared only with other Xerox equipment.
• Components may share the 36-inch / 91.4 cm general
service clearance areas, but they may not share the 24-inch /
61 cm operator area in front of each component.
• There must be 78 inches / 198 cm of vertical clearance
throughout the entire area.
NOTE: Finishers attached to your bypass transport may occupy
shared space with Xerox equipment. However, they must be
removable to allow servicing of the DocuPrint NPS printer
stackers. Consult with your Xerox representatives to ensure all
the requirements are met.
The following figures illustrate three possible configurations of
shared space.
Back-to-back
shared space
The figure below illustrates the two printers placed in a back-to-
back position. This allows them to share the entire 36 inches /
91.4 cm of general service space.