Xerox DocuPrint 4850, Installation Planning Manual

Page: 122 / 226

Installation
8-4 Installation Planning Guide
There are two appendices in this guide which provide printer
configuration procedures and the parameters you must define in
order to configure PSF to make a connection with your DocuPrint
NPS/IPS. One appendix discusses channel-attached
environments; the other appendix provides information for
environments in which the printer uses TCP/IP to communicate
via Ethernet or Token Ring. Parameters are given for MVS
mainframes, AS/400, RS/6000 running AIX, and PS/2 or other
personal computers running OS/2.
Software licensing
When a DocuPrint NPS/IPS is purchased, the owner needs to
receive a license to use the operating system software. Once a
user calls in with a host ID, (Sun SPARC/Ultra host ID), the user
receives a license string.
This license is enabled by entering a authorization text string at
the printer controller keyboard. Your Xerox service representative
obtains this license text string for you.
Until this license string is entered, while you power on and boot
the system, the printer remains in Disabled mode and cannot
print.
Although your service representative usually does this for you,
you also can enter your license string using the Install Feature
License command. For more information, refer to the “Using
utility commands” chapter of the Guide to Configuring and
Managing the System.
Ongoing maintenance
After the installation of your Xerox DocuPrint NPS/IPS, there are
a few ongoing tasks that must be performed. These tasks may
include the following:
• Maintaining an adequate inventory of consumable supplies
• Overseeing routine maintenance and meter reporting
• Arranging for additional operator training
• Ordering additional fonts
• Ordering additional documentation