wtw DIQ/S 282, Operating Manual, Page: 45 / 186

DIQ/S 28X Installation
45
ba77168d02 03/2017
Connecting lines
to the terminal
strip
Fig. 3-18 Inserting lines
1 On the left-hand side of the DIQ/S 28X, remove the two countersunk
screws and open the enclosure.
The complete assignment of the terminal strip is shown in
section 3.13.
2 Screw a cable gland (pos. 1 in Fig. 3-18) with the sealing ring (pos. 2)
into the enclosure below the respective connections.
3 Loosen the coupling ring (pos. 3).
4 Feed the line through the cable gland in the enclosure.
5 Connect the wires to the terminal strip. While doing so, pay attention to
the specifications on the label located under the terminal strip.
6 Tighten the coupling ring (pos. 3).
1
3
2
4
L
N