wtw DIQ/S 282, Operating Manual, Page: 100 / 186

Settings/setup DIQ/S 28X
100
ba77168d02 03/2017
5.8.3 Alarm output to display
When an alarm event occurs, a window with a text message appears.
Limit value  Lower limit
 Upper limit
Type of the alarm event.
Lower limit : An alarm is triggered if the
defined limit value is undercut.
Upper limit : An alarm is triggered if the
defined limit value is exceeded.
Lower limit /
Upper limit
within the measuring
range (sensor-depen-
dent) Limit value for the alarm event
Hysteresis 0 - 10 % of the measur-
ing range Hysteresis for the limit value
Designation (max. 20 characters) User-defined designation for easier identi-
fication in the alarm message.
Relay output Dxx / .../Ry
...
...
...
No relay output
Opens a list with all relay outputs where
the
Alarm contact is set.
Dxx: number of the output module
.../Ry: relay output channel
Here you can select a relay output. When
the alarm event occurs, it carries out the
specified action (Open or Close). For
details, see section 5.8.3 A
LARM OUTPUT
TO DISPLAY
.
Accept The settings are taken over in the setting
table by pressing
<OK> . The display
switches to the next higher level.
Cancel The display switches to the next higher
level without storing the new settings.
Menu item Selection/Values Explanations