Operation
*Tyre heating
130
2153734_02_BAL_GRW280_H195_en
© HAMM AG 2011
WARNING!
Cold burn!
Icing may occur at the surface of a liquid gas bottle and/or at the valves
when a big amount of liquid gas is withdrawn.
Adjust gas withdrawal correctly.
Wear personal protective equipment.
Ice which may have formed must not be removed unless by a slow
process. Do not knock off any ice, and do not apply any great heat
(e.g., use no flames).
002-65
1. Set the machine to the status described in the chapter
switching off engine, leaving machine
.
2. Carry an approved BC dry-powder extinguisher (at least 6 kg)
which is suitable for extinguishing liquid gas fires, and have this
extinguisher ready for use.
3. Remove the cover from the bottle bank (if available).
4. Unlock the transport slide [B], and pull it out to the front.
5. Make certain that every shut-off valve [C] (4 pieces) and the main
stop valve [D] have been shut.
6. Undo the lashing strap [E] of the bottle bank.
7. Undo the flexible tube fittings [G] leading to the liquid gas bottles.
Please note that the cylinder valves of the liquid gas bottles have
a left-hand thread.
8. Remove the empty liquid gas bottles [F], and replace them by full
liquid gas bottles.
9. Connect the flexible tube fittings [G] leading to the liquid gas bottles.
10.Tighten the lashing strap [E] of the bottle bank.
11.Slide in and lock the transport slide [B].
12.Install the cover at the bottle bank (if available).