45
2.
Operation
Summer mode, hot water only:
Set the operating mode to „DHW operation“
using the user module (installed in the living area).
Emergency operation:
In the event the system control fails, selecting the “Manual operation” mode using the MES control module
and InfoWINplus unit
(see section 2.6.5) will activate emergency operation to maintain heat and hot water.
2.10.2 BioWIN 2 with REG standard control
Information!
For operation of the REG standard control, please see their respective Operating instructions..
Boiler switching on, REG standard control to automatic operation:
1. Press the ON/OFF button
on the InfoWINplus panel, the lighting and display are switched on, the signal
lamp lights green and a self-test is performed (see also section 2.6.2). After a successful self-test and if a
setpoint is transferred by the system control, the BioWIN 2 automatically starts operation.
2. Set both manual switches to the “Automatic”
position.
3. Set the operating mode switch on the REG standard control unit RAM 786/RAM 850 to “Automatic operation“
-
please refer to the separate Operating instructions. The REG standard control unit RAM 786/RAM 850
(installed in the living area) is used to operate the system (set the desired temperature and operating times).
The time must also be set on the InfoWINplus (see section 2.9.1.3). This time is used for the time control of the
pellet feed and for automatic heating surface cleaning.
Fig. 119 BioWIN 2 with REG standard control
ON/OFF button
InfoWINplus operating unit
Automatic operation
Manual switch for heating pump
Manual switch for hot water tank pump
Fig. 120 REG-standard control RAM 786
Switching off heating system:
Set “Standby”
operating mode on the REG standard control unit (installed in the living area).
Summer mode, hot water only:
Set the operating mode to „DHW operation“
on the REG standard control unit (installed in the living area).
Fig. 121 REG-standard control RAM 850
