Mensor/WIKA Operating Instructions Series CPG 2500
37
Digital Pressure Gauge
SERIES CPG 2500
7.1.3 Serial Tab
Press this tab to set up the serial port parameters. The serial communication port allows
the CPG 2500 to communicate in RS-232 format with computers, terminals, PDAs, or
similar hosts.
These parameters should be set to match your host computer. Default settings are:
57600 baud, 8 data bits, 1 stop bit, no parity, and no echo.
If the echo checkbox is checked, the CPG 2500 will immediately echo back characters
sent over the serial port.
7.1.3.1 Cable Requirements
RS-232 communications are transmitted over a three conductor, shielded cable termi-
nated in a standard DB9 connector on the instrument end, and a different gender con-
nector on the host end. The proper pin-outs are shown in the following illustration.
!
Caution
CAUTION: When replacing an existing DPG 2100, the serial cable
should be replaced with a straight cable or a null-modem inserted in
the line.
Summary of Contents for SERIES CPG 2500
Page 87: ......
