All information, illustrations and specifications in this manual are based on the latest information
available at the time of publication. We reserve the right to make changes at any time without notice.
46
7.0. Operation
7.6. Faults and remedies
Description
Cause
Solution
The conveyer channel is
blocked
Height of the tools is too
low, so earth is being
gathered up
Set height of tine roller at
the front jockey wheels
Wear at protective rollers,
outside, on multi-cultivation
rail
Protective rollers set too
deep
Set protective rollers so
that they are not in
constant contact with the
ground
Turf is partially damaged
Verticutting knives have
been shortened by wear
Replace the verticutting
knives
Verticutting knives have
been worn down unevenly
Turn the verticutting knives
by 180° or replace them
Driving round bends that are
too tight during operation
Switch the P.T.O. shaft off
when driving round tight
bends
Different tire pressure at
wheels
Check the air pressure and
correct if necessary
Different adjustment of
jockey wheels or front roller
Check adjustment and
readjust id necessary
Different adjustment of the
two installed front rollers
Check adjustment on flat
solid ground and readjust if
necessary
The multi-maintenance
head cannot be lifted high
enough
Support was not turned
upward far enough
Turn support into its top
position
Drawbar for trailer coupling
incorrectly set
Set position of drawbar so
that the upper edge of the
machine is horizontal
Hopper is not lifted for high-
level tipping
Approved weight of load
exceeded.
Empty part of the load
without high-level tipping
Hydraulic system for lifting
and emptying the hopper is
not operating
Maintenance head not lifted
to end position therefore
pressure switch NOT
released for additional
functions
Lift maintenance head to
top position
Check pressure switch,
solenoid valve or electrical
control lines. Contact your
dealer if you still have
problems.
