12
Lit. No. 62639
October 5, 2001
INSTALLATION INSTRUCTIONS
Motor Terminal
POSITIVE
Motor Terminal
NEGATIVE
Large
Red
Wire
Large
Black Wire
Small Red
Wire–Female
Black/Orange Wire
Small Red
Wire–Male
Figure 27
CAUTION
Twisting motor stud while tightening cable nut
may damage the motor.
BATTERY CABLE ASSEMBLY
Refer to Figure 27 for the following instructions.
NOTE: Apply a light coating of dielectric grease
to connectors before assembly.
All parts installed in this section are found in the
hydraulics box.
1.
Attach the large red wire to the positive (+) motor
terminal on the hydraulic unit. Tighten nut to 50-60
in. lbs.
2.
Attach the large black wire and the black/orange
wire from the snowplow harness to the
NEGATIVE (-) motor terminal on the hydraulic unit.
Tighten nut to 50-60 in. lbs.
3.
Attach the small red wires by connecting the male
terminal to the female terminal.
4.
Slide the small pocket of the cable boot onto the
vertical tab of the boot bracket located on the lift
frame.
(See Figure 23 on previous page.)
Insert
the harness plugs into the boot for storage when the
snowplow is removed from the vehicle.
NOTE: Retain dielectric grease tube for use
during vehicle mount installation. Give the tube
to the end user.
